The gold bath JE270-2 is especially suitable for partial plating, for multi-colour processeing and reparation or restoration. The deposited coatings have a nice yellow gold colour. JE270-2 deposits uniform gold layers and has a strong colour consistency.

The plating layer created by pen plating is very thin. If you would like a thicker layer, we recommend that you treat the goods in a normal electroplating bath.
Jewellery parts that are not to be electroplated must then be covered with a suitable varnish.

*** Plus + 2 g gold quoted at the daily quotation***

Gold content: 2 g/100ml Au
Voltage: 6-8 Volt
Bath temperature: room temperature

Devices:
You will need a pen for plating (anode) with a replaceble felt as (+)- Pol and a tweezer/clamp (cathode) as (-)-Pol, each with a connecting cable as well as a rectifier (at least 10 V/2 Amp.).
Any available rectifier can be used.

Operating instructions:

• The parts must be cleaned, rinsed well and dried before the pen plating procedure.
  
• Insert a felt tip into the handpiece (plus pol) and plug also into the pen plating unit
  
• Fix the part with a pair of tweezers (minus pol) and plug in the pen plating unit. Dip the felt tip into the pen plating
  solution and wait 1 -2 minutes so that the solution can be adsorbed. Then insert the tip into the pen as far as possible
  
• Stroke several times without applying pressure the area to be electroplated.
  
• Rinse well in fresh water and dry the part

Anodes: pen for plating and felt
Cathode surface: tweezer or clamp
Voltage: 6-8 Volt
Temperature: room temperature
Treatment time: few seconds
Goods movement: pen strokes

To purchase this product, we require the signed declaration form in accordance with the German Chemicals Prohibition Ordinance (ChemVerbotsV), including the relevant supporting documents. Sale to private individuals is not permitted.

Notice according to REACH Regulation (EC) No. 1907/2006:

This product contains chemical substances that are subject to labelling requirements under REACH and CLP regulations.

Signal word: Danger

Hazard statements (H-statements)
H302 Harmful if swallowed. H332 Harmful if inhaled. H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H350i May cause cancer by inhalation.
H411 Toxic to aquatic life with long lasting effects.
EUH071 Corrosive to the respiratory tract.
Precautionary statements (P-statements)
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P301+P330+P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P303+P361+P353 IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin
with water [or shower].
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact
lenses, if present and easy to do. Continue rinsing.
P310 Immediately call a POISON CENTER or doctor.
P501.9 Dispose of contents/container as problematic waste.