The WILAPLAT Hard Bright Gilding Baths are cyanide electrolytes for the decorative gilding of nonferrous metals and precious metal alloys which are of different alloy composition and therefore differing in colour. The relatively thin plate layer is characterized by extreme hardness. All non-ferrous metals and stainless steels should be pre plated before colour gilding. The Wilaplat AC 3 SSF Pre-Plating [Adhesion Layer] Gold Bath (our ref. n° 3580.7770) is especially suitable for this application

WILAPLAT Hard Bright Gilding Baths are for use in conventional electroplating units such as the WILAPLAT-System. The surface must be degreased before gilding.

Data:

• Gold content** (g/l): 1,0


• Temperature (°C): 50 -60


• Exposure time (Sek): 20 – 30


• Voltage (Volt): 6 – 8


• Current Density (A/dm²): 5 – 8


• Deposition Rate (mg/Amin): 20


• Movement: not required


• Anodes: stainless steel


• Tank Material: glas, plastic


• Hardness (HV): 130 - 180


• Layer Thickness (µm): < 25

Supply form: dissolve the make-up salt in ¾ of final water volume and fill up.
Content (g): circa 25
Colour: pale yellow
Original Wieland n°.: 3100102103
Hazardous material: YES
Regeneration: not possible


**The content of precious metal will be charged according to the daily quotation!